For single, adjustable gold tube bracelets, you’ll need:
- a 2mm x 38mm curved noodle tube bead
- 2 feet of 0.5 mm chinese knotting cord
- an embroidery needle
- 2 spacer beads
Start by cutting the knotting cord into 2 12-inch pieces. Thread a gold noodle tube bead through one of the hairs and cross the ends.
And now, all that’s left is the moving closure! Comparable to our macrame bracelet, fold the 2nd strand over the overlapping ends and begin connecting square knots. Fold the top cord over the bottom cord …
… and bring the top cord under both the bottom and middle overlapping strands through the loop, into a knot.
Repeat the same step on the ideal side.
Continue to make 5-6 more knots.
To complete the knots, thread among the cables onto a needle and sew up the center of 2-3 knots along the backside. Pliers will assist pull the needle through the tight knots.
Trim away any excess cord.
Thread two gold spacer beads onto each cord and tie the suggestions into a knot. Trim.
Your adjustable & vibrant bracelets are done!
For a leather wrap gold tube bracelet, you’ll require:
7-8 3mm x 50mm curved noodle tube beads
1 backyard of 1.5 mm leather cord
2 crimp on cord ends
1 little spring or lobster clasp
a set of chain nose pliers
Place one end of the leather cord into the crimp-on cord end. Take a set of chain nose pliers and squeeze the middle of the end cap to secure the leather cord.
Thread on 7-8 gold noodle tube beads.
Wrap the bracelet around the wrist to assess the proper length. Trim and crimp on the second-end cap.
Utilizing the pliers, open the diving ring linked to the clasp and link it to one of the end caps.
Wrap, close, and your bracelet is complete!
Layer and enjoy.